Jordane Cosmetics

Jordane Total Tattoo Coverage Palette - Dark Tones

$80.00
In stock
SKU
JTTC-DARK
  • The basics

    A specially formulated cover-up, it's waterproof as well as smudge and transfer-resistant. It's also highly pigmented and dries incredibly fast. 

  • The benefits

    It doesn't require any activator or setting powder.

  • The uses

    Aside from tattoos, you can use Jordane to cover up dark circles and any other blemish or imperfection.

  • The bottom line

    Get impeccable tattoo coverage with this Jordane Palette.

Directions for total tattoo coverage:

Step 1: Use an astringent or something similar to remove any excess oils or grease from the skins surface for maximum adhesion.

Step 2: For dark pigmented tattoos start with an orange or rose coloured alcohol paint to neutralize the dense colour. You do not paint it out; just dull the intensity of the blacks. This will dry in seconds.

Step 3: With a spatula separate a small amount of cream foundation from the individual squares and place it on the inside of the cover and use the lid as a palette. This way you do not contaminate the individual squares of pigment.

Step 4: With a brush or sponge you can now apply the colour to the model’s skin. Use at least three flesh tones and apply the colours in layers. Allow twenty to thirty seconds for each layer to dry on the skin. The cream is heat activated so the use of a hairdryer will set the colour quicker. Test with you finger; the colour will be smudge proof. Once the layer is dry apply the second. Dry it and continue until the tattoo is covered to your satisfaction.

Step 5: If the tattoo is to come in contact with wardrobe a fixer spray is recommended for added protection. A water based sealer is preferred, such as Jordane’s Aqua Bamboo.

NOTE: If too much color is applied it will dry crusty in appearance and can flake off. This dried surface can be thinned and blended with 99% Isopropyl Alcohol. The same can be done to any densely colored edges. Blend with an alcohol dampened sponge or brush.

Directions for scar and discoloured skin coverage:

Step 1: Use an astringent or something similar to remove any excess oils or grease for maximum adhesion.

Step 2: With a spatula separate a small amount of cream foundation from the individual squares and place it on the inside of the cover and use the lid as a palette. This way you do not contaminate the individual squares of pigment.

Step 3: Thin the cream colour with a few drops of the Total Tattoo Coverage Rejuvenating Serum.

Step 4: With a brush or sponge you can now apply the colour to the model’s skin. Use at least three flesh tones and apply the colours in layers. Allow twenty to thirty seconds for each layer to dry on the skin. The cream is heat activated so the use of a hairdryer will set the colour quicker. Test with you finger; the colour will be smudge proof. Once the layer is dry apply the second. Dry it and continue until the imperfection is covered to your satisfaction.

Step 5: If the scar or imperfection is to come in contact with wardrobe a fixer spray is recommended for added protection. A water based sealer is preferred, such as Jordane’s Aqua Bamboo.

NOTE: If too much color is applied it will dry crusty in appearance and can flake off. This dried surface can be thinned and blended with 99% Isopropyl Alcohol. The same can be done to any densely colored edges. Blend with an alcohol dampened sponge or brush.

Your Rating*

Success! Your Review has been accepted for moderation.

More Products You Might Like